ee:eagle
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
ee:eagle [2023/10/21 11:12] 26364@students.hsrw |
ee:eagle [2023/10/22 17:32] (current) 26364@students.hsrw |
||
|---|---|---|---|
| Line 175: | Line 175: | ||
| 7. Place connected components near each other to minimize path length and path crossings. The yellow lines mark the connections you will have to route later. | 7. Place connected components near each other to minimize path length and path crossings. The yellow lines mark the connections you will have to route later. | ||
| - | {{ :ee:b9.jpg |}} | + | {{ :ee:screenshot_53_.png?400 |}} |
| 8. Click ’ ratsnest’ to force EAGLE to redraw the yellow lines. | 8. Click ’ ratsnest’ to force EAGLE to redraw the yellow lines. | ||
| Line 181: | Line 181: | ||
| {{ :ee:b6.jpg |}} | {{ :ee:b6.jpg |}} | ||
| - | |||
| - | {{ :ee:b10.jpg |}} | ||
| Line 188: | Line 186: | ||
| as font. | as font. | ||
| - | {{ :ee:b11.jpg |}} | + | {{ :ee:b11.jpg?600 |}} |
| 10. After the last step the board may look like the picture below. | 10. After the last step the board may look like the picture below. | ||
| - | {{ :ee:b12.jpg |}} | + | {{ :ee:screenshot_423_.png?400 |}} |
| 11. To set the default track size Go to Edit → net classes and change the width of the default net class to 0.8mm. | 11. To set the default track size Go to Edit → net classes and change the width of the default net class to 0.8mm. | ||
| - | {{ :ee:b13.jpg |}} | + | {{ :ee:b13.jpg?600 |}} |
| 12. The next step is routing. There are two different approaches to this problem. Manual routing is described here. | 12. The next step is routing. There are two different approaches to this problem. Manual routing is described here. | ||
| Line 208: | Line 206: | ||
| • If a connection is made the yellow line should disappear. If it persists you have to look for the error. | • If a connection is made the yellow line should disappear. If it persists you have to look for the error. | ||
| - | for a better and easier connection let’s define a ground plane on the bottom layer. use the ’polygon’ tool to make a rectangle around the dimension of your board. | + | for a better and easier connection let’s define a ground plane on the bottom layer and top layer. use the ’polygon’ tool to make a rectangle around the dimension of your board. |
| + | |||
| + | 13. Start by making GND polygons and don't forget to name it GND | ||
| + | |||
| + | {{ :ee:screenshot_43_.png?400 |}}{{ :ee:screenshot_47_.png?400 |}} | ||
| + | |||
| + | 14. start routing the connections | ||
| + | |||
| + | {{ :ee:screenshot_54_.png?400 |}} | ||
| + | {{ :ee:screenshot_55_.png?400 |}} | ||
| + | |||
| + | 15. don't forget to add via to connect the top GND to the bottom GND with GND as the signal name | ||
| + | |||
| + | {{ :ee:screenshot_57_.png?400 |}} | ||
ee/eagle.1697879533.txt.gz · Last modified: 2023/10/21 11:12 by 26364@students.hsrw
Page Tools
